Overcenter valve 60l/m 75-140 bar CB10 HV-2-B-1-E-XXX-B-00
CB10-HV, Hydraulic Vent Valve.
Operation
CB10-HV: Counterbalance valve, 10-size, hydraulic vent. This valve is 3-ported, externally piloted and low leakage. The check section allows free flow from the directional valve (port 2) to the load (port 1), while normally blocking flow from port 1 to port 2. Reverse flow is blocked until pilot pressure is applied at port 3. When the load pressure at port 1 rises above the pressure setting, the integral relief valve is activated, and pressure is relieved from port 1 to port 2.
Applications
Single counterbalance valves are normally used when the load is unidirectional, such as aerial lifts, cranes, or winches. In load holding applications, they can be used as hose-break valves when installed near or within an actuator. Dual valves can be used for controlling loads bi-directionally in motor applications, or for cylinders going over center.
Artikelnummer:
860103319
Förpackningsstorlek:
0 pcs
Minsta beställningskvantitet:
1 pcs
Brand Name
Danfoss
Cavity
SDC10-3S
Contamination level max.
20/18/14 - ISO 4406
Flow rate nominal LMin
60 lpm
Model code
CB10-HV-2-B-1-E-XXX-B-00
Oil viscocity recommended
12 - 54 cSt
Pilot ratio
4,5:1
Pressure max.
350 bar
Pressure setting max.
240 bar
Pressure setting min.
75 bar
Sealing material
NBR
Torque tightening
45 - 50 Nm
Pakke str.
0 pcs
Stregkode
5704334370413
Brutto vægt
0,23 Kg
Netto vægt
0,23 Kg
Oprindelsesland
Intrastat varekode
84812010
CB10-HV, Hydraulic Vent Valve.
Operation
CB10-HV: Counterbalance valve, 10-size, hydraulic vent. This valve is 3-ported, externally piloted and low leakage. The check section allows free flow from the directional valve (port 2) to the load (port 1), while normally blocking flow from port 1 to port 2. Reverse flow is blocked until pilot pressure is applied at port 3. When the load pressure at port 1 rises above the pressure setting, the integral relief valve is activated, and pressure is relieved from port 1 to port 2.
Applications
Single counterbalance valves are normally used when the load is unidirectional, such as aerial lifts, cranes, or winches. In load holding applications, they can be used as hose-break valves when installed near or within an actuator. Dual valves can be used for controlling loads bi-directionally in motor applications, or for cylinders going over center.
Copyright © 2026 HydraSpecma