Overcenter valve 60l/m 75-140 bar CB10 HV-2-B-1-E-XXX-B-00
CB10-HV, Hydraulic Vent Valve.
Operation
CB10-HV: Counterbalance valve, 10-size, hydraulic vent. This valve is 3-ported, externally piloted and low leakage. The check section allows free flow from the directional valve (port 2) to the load (port 1), while normally blocking flow from port 1 to port 2. Reverse flow is blocked until pilot pressure is applied at port 3. When the load pressure at port 1 rises above the pressure setting, the integral relief valve is activated, and pressure is relieved from port 1 to port 2.
Applications
Single counterbalance valves are normally used when the load is unidirectional, such as aerial lifts, cranes, or winches. In load holding applications, they can be used as hose-break valves when installed near or within an actuator. Dual valves can be used for controlling loads bi-directionally in motor applications, or for cylinders going over center.
Artikelnummer:
860103319
Förpackningsstorlek:
1 st
Minsta beställningskvantitet:
1 st
Cavity
SDC10-3S
Flow Nominel
60 lpm
Forureningsgrad maks.
20/18/14 - ISO 4406
Model kode
CB10-HV-2-B-1-E-XXX-B-00
Mærke navn
Danfoss
Olieviskositet anbefalet
12 - 54 cSt
Pakningsmateriale
NBR
Pilotforhold
4,5:1
Tilspændingsmoment
45 - 50 Nm
Tryk maks.
350 bar
Trykindstilling maks.
240 bar
Trykindstilling min.
75 bar
Förpackningsstorlek
1 st
Streckkod
374746
Bruttovikt
0,23 Kg
Nettovikt
0,23 Kg
Ursprungsland
Intrastat artikelkod
84812010
CB10-HV, Hydraulic Vent Valve.
Operation
CB10-HV: Counterbalance valve, 10-size, hydraulic vent. This valve is 3-ported, externally piloted and low leakage. The check section allows free flow from the directional valve (port 2) to the load (port 1), while normally blocking flow from port 1 to port 2. Reverse flow is blocked until pilot pressure is applied at port 3. When the load pressure at port 1 rises above the pressure setting, the integral relief valve is activated, and pressure is relieved from port 1 to port 2.
Applications
Single counterbalance valves are normally used when the load is unidirectional, such as aerial lifts, cranes, or winches. In load holding applications, they can be used as hose-break valves when installed near or within an actuator. Dual valves can be used for controlling loads bi-directionally in motor applications, or for cylinders going over center.
Copyright © 2025 HydraSpecma