Sequence valve 240l/min 350bar
Direct-acting sequence valves with reverse-flow check will supply a secondary circuit with flow once the pressure at the inlet (port 1) has exceeded the valve setting. Additionally, these valves incorporate an integral check valve to provide reverse flow from port 2 (sequence) to port 1 (inlet). The pressure setting of a sequence valve controls the pressure at port 1 relative to the pressure at the drain (port 3).
- All 3 port sequence cartridges are physically and functionally interchangeable (i.e. same flow path, same cavity for a given frame size).
- Although this is a zero pilot flow valve, port 3 (drain) must be connected to maintain a pressure reference in the control chamber. If port 3 is blocked, reciprocating seal weepage will cause the valve to malfunction.
- Pressure at port 3 is directly additive to the valve setting at a 1:1 ratio and should not exceed 350 bar.
- Suitable for use in load holding applications.
- Incorporates the Sun floating style construction to minimize the possibility of internal parts binding due to excessive installation torque and/or cavity/cartridge machining variations.
Partnumber:
SCGA-LDN
Package size:
1 st
Min. order quantity is:
1 st
Flödeshastighet nominell LMin
240 lpm
Föroreningsgrad max.
19/17/14 - ISO 4406
Kavitet
T-17A
Märke namn
Sun Hydraulics
Oljeviskositet rekommanderad
2,8 - 380 cSt
Packningsmaterial
NBR
Temperatur max.
+110 °C
Temperatur min.
-30 °C
Tillverkningsmaterial
Steel
Tryck max.
350 bar
Tryckinställning max.
55 bar
Tryckinställning min.
14 bar
Åtdragning moment
203 - 217 Nm
Package size
1 st
Barcode
305016
Gross weight
0,30 Kg
Net weight
0,30 Kg
Country of origin
usa
Intrastat code
84812010
Direct-acting sequence valves with reverse-flow check will supply a secondary circuit with flow once the pressure at the inlet (port 1) has exceeded the valve setting. Additionally, these valves incorporate an integral check valve to provide reverse flow from port 2 (sequence) to port 1 (inlet). The pressure setting of a sequence valve controls the pressure at port 1 relative to the pressure at the drain (port 3).
- All 3 port sequence cartridges are physically and functionally interchangeable (i.e. same flow path, same cavity for a given frame size).
- Although this is a zero pilot flow valve, port 3 (drain) must be connected to maintain a pressure reference in the control chamber. If port 3 is blocked, reciprocating seal weepage will cause the valve to malfunction.
- Pressure at port 3 is directly additive to the valve setting at a 1:1 ratio and should not exceed 350 bar.
- Suitable for use in load holding applications.
- Incorporates the Sun floating style construction to minimize the possibility of internal parts binding due to excessive installation torque and/or cavity/cartridge machining variations.
Copyright © 2025 HydraSpecma