C.B. Valve 20l/m 124-345bar CP448-1-B-0-E-C-XXX-3.0-040
Overcenter Valve, Standard, Direct Acting, Internal Drain, Port 3 Pilot
This is a direct acting overcenter valve, which is a pilot assisted relief with a free flow check. With the relief valve set at approximately 1.3 times the maximum load induced pressure, the valve will prevent flow from port 1 to 2. When pilot pressure is applied to port 3, the valve will meter the flow from port 1 to 2, compensating for any change in pilot pressure due to over-running or unstable loads. Free flow takes place from port 2 to port 1 through the check portion of the valve.
These valves are ideal in most applications bringing stability, load holding, and hose failure protection when the valve is mounted onto or into the actuator. The spring chamber is connected to the valve port 2, so any back pressure will increase the pilot pressure required to keep the valve open and the pressure at which the valve will open as a relief valve.
Artikelnummer:
134506.000
Förpackningsstorlek:
1 st
Minsta beställningskvantitet:
1 st
Flödeshastighet nominell LMin
20 lpm
Föroreningsgrad max.
20/18/14 - ISO 4406
Kavitet
CP08-3L
Modell kod
CP448-1-B-0-E-C-XXX-3.0-040
Märke namn
Danfoss
Oljeviskositet rekommanderad
12 - 54 cSt
Packningsmaterial
NBR
Pilot förhållande
3:1
Tryck max.
350 bar
Tryckinställning max.
350 bar
Tryckinställning min.
124 bar
Åtdragning moment
34 - 41 Nm
Pakke str.
1 st
Stregkode
374691
Brutto vægt
0,18 Kg
Netto vægt
0,18 Kg
Oprindelsesland
ITA
Intrastat varekode
84812010
Overcenter Valve, Standard, Direct Acting, Internal Drain, Port 3 Pilot
This is a direct acting overcenter valve, which is a pilot assisted relief with a free flow check. With the relief valve set at approximately 1.3 times the maximum load induced pressure, the valve will prevent flow from port 1 to 2. When pilot pressure is applied to port 3, the valve will meter the flow from port 1 to 2, compensating for any change in pilot pressure due to over-running or unstable loads. Free flow takes place from port 2 to port 1 through the check portion of the valve.
These valves are ideal in most applications bringing stability, load holding, and hose failure protection when the valve is mounted onto or into the actuator. The spring chamber is connected to the valve port 2, so any back pressure will increase the pilot pressure required to keep the valve open and the pressure at which the valve will open as a relief valve.
Copyright © 2025 HydraSpecma