Tryckreduceringsventil SUN T-163A
Pilot-operated, pressure reducing valves reduce a high primary pressure at the inlet (port 2) to a constant reduced pressure at port 1, allowing circuits with multiple pressure requirements to be operated using a single pump.
- Full reverse flow from reduced pressure (port 1) to inlet (port 2) may cause the main spool to close. If reverse free flow is required in the circuit, consider adding a separate check valve to the circuit.
- Pilot operated valves exhibit exceptionally flat pressure/flow characteristics, are very stable and have low hysteresis.
- Pressure at port 3 is directly additive to the valve setting at a 1:1 ratio and should not exceed 350 Bar.
- Recommended maximum inlet pressure for this valve is 210 Bar maximum differential between inlet and reduced pressure.
- Incorporates the Sun floating style construction to minimize the possibility of internal parts binding due to excessive installation torque and/or cavity/cartridge machining variations.
Varenummer:
PBBB-LBN
Pakkestr.:
1 pcs
Min. bestillingsmengde er:
1 pcs
Flow Nominel LMin
20 lpm
Forureningsgrad maks.
19/17/14 - ISO 4406
Hulrom
T-163A
Materiale
Steel
Merke navn
Sun Hydraulics
Oljeviskositet anbefales
2,8 - 380 cSt
Pakningsmateriale
NBR
Temperatur maks.
+110 °C
Temperatur min.
-30 °C
Tilspenning moment
27 - 33 Nm
Trykk maks.
350 bar
Trykkindstilling maks.
105 bar
Tykkindstilling min.
5 bar
Pakkestr.
1 pcs
Strekkode
297381
Bruttovekt
Kg
Nettovekt
Kg
Opprinnelsesland
usa
Pilot-operated, pressure reducing valves reduce a high primary pressure at the inlet (port 2) to a constant reduced pressure at port 1, allowing circuits with multiple pressure requirements to be operated using a single pump.
- Full reverse flow from reduced pressure (port 1) to inlet (port 2) may cause the main spool to close. If reverse free flow is required in the circuit, consider adding a separate check valve to the circuit.
- Pilot operated valves exhibit exceptionally flat pressure/flow characteristics, are very stable and have low hysteresis.
- Pressure at port 3 is directly additive to the valve setting at a 1:1 ratio and should not exceed 350 Bar.
- Recommended maximum inlet pressure for this valve is 210 Bar maximum differential between inlet and reduced pressure.
- Incorporates the Sun floating style construction to minimize the possibility of internal parts binding due to excessive installation torque and/or cavity/cartridge machining variations.
Copyright © 2026 HydraSpecma