Sun pressure relief valve 10-
This pilot-operated, balanced-piston relief cartridges are normally closed pressure regulating valves. When the pressure at the inlet (port 1) reaches the valve setting, the valve starts to open to tank (port 2), throttling flow to regulate the pressure. These valves are accurate, have low pressure rise vs. flow, they are smooth and quiet, and are moderately fast.
- All 2-port relief cartridges (except pilot reliefs) are physically and functionally interchangeable (same flow path, same cavity for a given frame size).
- Will accept maximum pressure at port 2; suitable for use in cross port relief circuits. If used in cross port relief circuits, consider spool leakage.
- Main stage orifice is protected by a 150-micron stainless steel screen.
- Not suitable for use in load holding applications due to spool leakage.
- Back pressure on the tank port (port 2) is directly additive to the valve setting at a 1:1 ratio.
- Incorporates the Sun floating style construction to minimize the possibility of internal parts binding due to excessive installation torque and/or cavity/cartridge machining variations.
Artikelnummer:
RPEC-LCN
Förpackningsstorlek:
1 st
Minsta beställningskvantitet:
1 st
Brand Name
Sun Hydraulics
Cavity
T-10A
Contamination level max.
19/17/14 - ISO 4406
Flow rate nominal LMin
95 lpm
Material
Steel
Oil viscocity recommended
2,8 - 380 cSt
Pressure T max.
350 bar
Pressure max.
350 bar
Pressure setting max.
420 bar
Pressure setting min.
10.5 bar
Sealing material
NBR
Temperature max.
+110 °C
Temperature min.
-30 °C
Torque tightening
41 - 47 Nm
Förpackningsstorlek
1 st
Streckkod
159479
Bruttovikt
0,15 Kg
Nettovikt
0,15 Kg
Ursprungsland
Intrastat artikelkod
84812010
This pilot-operated, balanced-piston relief cartridges are normally closed pressure regulating valves. When the pressure at the inlet (port 1) reaches the valve setting, the valve starts to open to tank (port 2), throttling flow to regulate the pressure. These valves are accurate, have low pressure rise vs. flow, they are smooth and quiet, and are moderately fast.
- All 2-port relief cartridges (except pilot reliefs) are physically and functionally interchangeable (same flow path, same cavity for a given frame size).
- Will accept maximum pressure at port 2; suitable for use in cross port relief circuits. If used in cross port relief circuits, consider spool leakage.
- Main stage orifice is protected by a 150-micron stainless steel screen.
- Not suitable for use in load holding applications due to spool leakage.
- Back pressure on the tank port (port 2) is directly additive to the valve setting at a 1:1 ratio.
- Incorporates the Sun floating style construction to minimize the possibility of internal parts binding due to excessive installation torque and/or cavity/cartridge machining variations.
Copyright © 2025 HydraSpecma