OVERCENTER VALVE, CB10 CB10 HV-1-C-1-E-XXX-B-00
CB10-HV, Hydraulic Vent Valve.
Operation
CB10-HV: Counterbalance valve, 10-size, hydraulic vent. This valve is 3-ported, externally piloted and low leakage. The check section allows free flow from the directional valve (port 2) to the load (port 1), while normally blocking flow from port 1 to port 2. Reverse flow is blocked until pilot pressure is applied at port 3. When the load pressure at port 1 rises above the pressure setting, the integral relief valve is activated, and pressure is relieved from port 1 to port 2.
Applications
Single counterbalance valves are normally used when the load is unidirectional, such as aerial lifts, cranes, or winches. In load holding applications, they can be used as hose-break valves when installed near or within an actuator. Dual valves can be used for controlling loads bi-directionally in motor applications, or for cylinders going over center.
Varenummer:
860102019
Pakke str.:
0 pcs
Min. bestillingsenhed er:
1 pcs
Flow Nominel LMin
60 lpm
Forureningsgrad maks.
20/18/14 - ISO 4406
Hulrom
SDC10-3S
Merke navn
Danfoss
Modell kode
CB10-HV-1-C-1-E-XXX-B-00
Oljeviskositet anbefales
12 - 54 cSt
Pakningsmateriale
NBR
Pilotforhold
10:1
Tilspenning moment
45 - 50 Nm
Trykk maks.
350 bar
Trykkindstilling maks.
350 bar
Tykkindstilling min.
90 bar
Pakkestr.
0 pcs
Strekkode
5704334370406
Bruttovekt
0,22 Kg
Nettovekt
0,22 Kg
Opprinnelsesland
Intrastat produktkode
84812010
CB10-HV, Hydraulic Vent Valve.
Operation
CB10-HV: Counterbalance valve, 10-size, hydraulic vent. This valve is 3-ported, externally piloted and low leakage. The check section allows free flow from the directional valve (port 2) to the load (port 1), while normally blocking flow from port 1 to port 2. Reverse flow is blocked until pilot pressure is applied at port 3. When the load pressure at port 1 rises above the pressure setting, the integral relief valve is activated, and pressure is relieved from port 1 to port 2.
Applications
Single counterbalance valves are normally used when the load is unidirectional, such as aerial lifts, cranes, or winches. In load holding applications, they can be used as hose-break valves when installed near or within an actuator. Dual valves can be used for controlling loads bi-directionally in motor applications, or for cylinders going over center.
Copyright © 2026 HydraSpecma