Counter balance 115l/m CP441-1-V-0-E-B-XXX-4.5-015
CP441-1, Hydraulic Vent Valve
Operation
This 3-ported, externally piloted unit is a 12-size cartridge style, low leakage counterbalance valve with hydraulic vent. The check section allows free flow from the directional valve (port 2) to the load (port 1), while normally blocking flow from port 1 to port 2. Reverse flow is blocked until pilot pressure is applied at port 3. When the load pressure at port 1 rises above the pressure setting, the integral relief valve is activated, and pressure is relieved from port 1 to port 2.
Applications
Single counterbalance valves are normally used when the load is unidirectional, such as aerial lifts, cranes, or winches. In load holding applications, they can be used as hose-break valves when installed near or within an actuator. Dual valves can be used for controlling loads bi-directionally in motor applications, or for cylinders going over center.
Varenummer:
132786
Pakke str.:
0 pcs
Min. bestillingsenhed er:
1 pcs
Brand Name
Danfoss
Cavity
CP12-3S
Contamination level max.
20/18/14 - ISO 4406
Flow rate nominal LMin
115 lpm
Model code
CP441-1-V-0-E-B-XXX-4.5-015
Oil viscocity recommended
12 - 54 cSt
Pilot ratio
4,5:1
Pressure max.
350 bar
Pressure setting max.
103 bar
Pressure setting min.
103 bar
Torque tightening
68 - 75 Nm
Pakke str.
0 pcs
Stregkode
5704334410584
Brutto vægt
0,63 Kg
Netto vægt
0,63 Kg
Oprindelsesland
Intrastat varekode
84812010
CP441-1, Hydraulic Vent Valve
Operation
This 3-ported, externally piloted unit is a 12-size cartridge style, low leakage counterbalance valve with hydraulic vent. The check section allows free flow from the directional valve (port 2) to the load (port 1), while normally blocking flow from port 1 to port 2. Reverse flow is blocked until pilot pressure is applied at port 3. When the load pressure at port 1 rises above the pressure setting, the integral relief valve is activated, and pressure is relieved from port 1 to port 2.
Applications
Single counterbalance valves are normally used when the load is unidirectional, such as aerial lifts, cranes, or winches. In load holding applications, they can be used as hose-break valves when installed near or within an actuator. Dual valves can be used for controlling loads bi-directionally in motor applications, or for cylinders going over center.
Copyright © 2025 HydraSpecma