C.B. Valve 60l/m 55-80bar 4.5:1 CB10-HV-1-B-1-F-55-B-00(TN)
CB10-HV, Hydraulic Vent Valve.
Operation
CB10-HV: Counterbalance valve, 10-size, hydraulic vent. This valve is 3-ported, externally piloted and low leakage. The check section allows free flow from the directional valve (port 2) to the load (port 1), while normally blocking flow from port 1 to port 2. Reverse flow is blocked until pilot pressure is applied at port 3. When the load pressure at port 1 rises above the pressure setting, the integral relief valve is activated, and pressure is relieved from port 1 to port 2.
Applications
Single counterbalance valves are normally used when the load is unidirectional, such as aerial lifts, cranes, or winches. In load holding applications, they can be used as hose-break valves when installed near or within an actuator. Dual valves can be used for controlling loads bi-directionally in motor applications, or for cylinders going over center.
Varenummer:
11107233
Pakke str.:
0 pcs
Min. bestillingsenhed er:
1 pcs
Brand Name
Danfoss
Cavity
SDC10-3S
Contamination level max.
20/18/14 - ISO 4406
Flow rate nominal LMin
60 lpm
Model code
CB10-HV-1-B-1-F-55-B-0
Oil viscocity recommended
12 - 54 cSt
Pilot ratio
4,5:1
Pressure max.
350 bar
Pressure setting max.
55 bar
Sealing material
NBR
Torque tightening
45 - 50 Nm
Pakke str.
0 pcs
Stregkode
5704334467199
Brutto vægt
Kg
Netto vægt
Kg
Oprindelsesland
ITA
Intrastat varekode
84812010
CB10-HV, Hydraulic Vent Valve.
Operation
CB10-HV: Counterbalance valve, 10-size, hydraulic vent. This valve is 3-ported, externally piloted and low leakage. The check section allows free flow from the directional valve (port 2) to the load (port 1), while normally blocking flow from port 1 to port 2. Reverse flow is blocked until pilot pressure is applied at port 3. When the load pressure at port 1 rises above the pressure setting, the integral relief valve is activated, and pressure is relieved from port 1 to port 2.
Applications
Single counterbalance valves are normally used when the load is unidirectional, such as aerial lifts, cranes, or winches. In load holding applications, they can be used as hose-break valves when installed near or within an actuator. Dual valves can be used for controlling loads bi-directionally in motor applications, or for cylinders going over center.
Copyright © 2026 HydraSpecma