CASAPPA

...passion for high performance in hydraulics

CASAPPA designs and manufactures the main components of hydraulic systems with passion and care in detail.

With its more than 60 years in the field their experience in hydraulic components is high.

CASAPPA IN HYDRASPECMA WEBSHOP

CASAPPA SPECIALISES IN THE FOLLOWING AREAS:

Construction Equipment – On-highway Vehicles – Material Handling – Agriculture – Mining – General Industry

ALUMINIUM GEAR PUMPS & MOTORS

Pumps and motors are built in three pieces with an extruded body in high resistance aluminium alloy.

The wide choice of shafts, flanges and ports, in compliance with all international standards (SAE, DIN and EUROPEAN) allow for their use in an infinite variety of applications.

Displacements from 0.07 in³/rev (1.07 cm³/rev) to 5.56 in³/rev (91.10 cm³/rev) available in groups 10, 20 and 30.
Max. peak pressure up to 4,350 psi (300 bar).
Max. speed up to 4,000 min^-1

GEAR PUMPS & MOTORS

CAST IRON GEAR PUMPS

Ideal for truck application.

Displacements from 0.50 in³/rev (8.26 cm³/rev) to 9.20 in³/rev (150.79 cm³/rev) available in groups 20, 30, 35 and 40.
Max. peak pressure up to 4713 psi (325 bar).
Max. speed up to 3000 min^-1

High performance also at very low speeds
Different ports position availability
Low noise emission
Shaft seal system no leakage guarantee
Modular design
Direct mounting on the PTOs

CAST IRON PUMPS

VARIABLE DISPLACEMENT AXIAL PISTON PUMPS

PLATA pumps are ideally suited for medium and high-pressure open circuit applications.

Displacements from 1.75 in³/rev (28.7 cm³/rev) to 5.36 in³/rev (87.9 cm³/rev)
Max. peak pressure up to 5,075 psi (350 bar)
Max. speed up to 3,000 min^-1

Energy saving
Low noise emission
Short response time
Drive shaft bearing suitable for radial and axial loads
Multiple combinations

GEAR FLOW DIVIDERS

Made of high-resistance aluminium alloy.

These components can be used as flow equalizers, flow dividers and pressure intensifiers.

Displacements from 0.13 in³/rev (2.14 cm³/rev) to 2.01 in³/rev (33.03 cm³/rev) available in groups 10 and 20.
Max. peak pressure up to 4,060 psi (280 bar).

Modular design
Accurate division of flow
Built-in relief valves
Combinations between different groups

GEAR FLOW DIVIDERS

NEED HELP FINDING YOUR NEXT GEAR PUMP OR MOTOR?

Whether you are looking to buy your first gear pump or motor, or you are in the market to upgrade your current ones, we can help you.

CONTACT US